Special machine for large parts
DESMA special machines for the production of large-sized high-tension insulators
Depending on the voltage level, high-tension insulators are often several meters long. In the injection molding process they are usually produced by applying the "Step-Molding-Method". However, with the number of steps being increased, the total cycle time rises as well. If the insulators are manually transferred, there will be the risk of an increased reject rate as a result of an operating error.
Cost-saving solutions in the process technology of DESMA
On the basis of a D 968.560 ZO BENCHMARK 750 DESMA developed a special machine which enables the injection molding of 1,500 mm long articles in one piece by means of mold carrier platens lengthened to 1,700 mm. So the number of steps could be more than halved. The new D 968.700 T has been recently added for article lengths of up to 1,700 mm.
This special machine can be optionally fitted with a LSR injection unit which makes a maximum injection volume of 11,000 cm³ possible. Due to the fact that that liquid silicone is being applied, the injection unit is sufficiently dimensioned with a pressure of 1,000 bar. The injection mold with quickly changeable inserts was developed and produced by the DESMA mold shop. Compared to conventional injection units for customary elastomers, clear cost benefits can be achieved.
As an option, this injection molding machine can be equipped with a special LSR injection unit which allows for a maximum injection volume of 11,000 cm³. Since liquid silicone is applied, the injection unit is sufficiently dimensioned for a pressure of 1,000 bar. The injection mold with quickly exchangeable inserts was developed and produced in the DESMA in-house mold shop. As against conventional injection units for standard elastomers, substantial cost advantages can be achieved.