Skip to navigation Skip to content

DESMA ZeroWaste ITM pot

ZeroWaste ITM
ZeroWaste ITM

A tremendous cost saving of                                   30 % to 50 % was realized

Latest ITM technology for runner-loss-free direct injection an integrated hydraulic needle shut-off system. Ideally suited to produce small seals with low waste. These ITM (Injection Transfer Moulding) pots enable many injection nozzles which is not feasible with standard cold runner systems. Additionally, a special software is used in order to run appropriate clamping profiles. The hydraulic surface ratios in the so-calles transfer chamber and the article deck underneath lead to a perfect mould compressing which may enable a rework-free article production.

Advantages

  • Temperature-controlled distributing pot with hydraulically actuated shut-off needles
  • Direct injection of precision articles without runner loss
  • Production solutions including zero-waste article manufacture are feasible



Which cold runner is the ideal one?